2" Blind : How To Rewind A Cord Tilt

Parts Related To This Repair:
High Profile Cord Tilter
Low Profile Cord Tilter

1. Locate hole in backside of wheel on cord tilt mechanism (see arrow in picture to right).		6. With same side of cord, set in slot on wheel and then wrap cord four times around wheel in a clockwise direction.
2. Feed one end of approximately 11 feet of cord through hole in wheel.		7. With other end of cord, set in slot on front of wheel and wrap cord in the opposite direction, counter-clockwise, four times.
3. Pull half of length of cord through wheel.		8. Feed each end of cord into holes of hinged part of tilt mechanism.
4. Cross over cord on wheel through slots.		9. Fold up hinged part of tilt mechanism and test cording by pulling on one end of cord and then the other to ensure smooth operation of tilt mechanism.
5. Feed end of crossed-over cord back through hole in wheel. cord into holes of hinged part of tilt mechanism.

 Download 2" Blind: How To Rewind A Cord Tilt

Get free Adobe Acrobat Reader to download and view PDF files.